Eight of Satin

To create a souvenir, you will need: - blank paper. - pencil. - ruler. - cardboard box. - scissors. - glue gun with a replaceable rod.
- purple satin ribbon not less than 50 mm wide. - narrow lilac ribbon. - green ribbon 25 mm wide. - lighter. - magnet. - rhinestones of different diameters purple. - a cabochon of lilac color with a diameter of 13 mm. Creating a souvenir-magnet. First, on a piece of paper you need to draw a blank, on which the souvenir will be cut. On a clean a sheet of paper cl blowing create a drawing corresponding to the dimensions shown in the photo.
 Eight of satin
According to the drawn contours, the part must be cut, resulting in the figure 8.
 Eight of Satin
The blank is made, then you should cut the base out of thick cardboard, but it is better out of the box.
 Eight of satin
Now, the resulting part should be wrapped with a narrow purple ribbon. Start better from the middle.Gently fixing the edge of the tape with glue, you need to wrap the tape around the cardboard once, and gradually move to the rounded part.  Eight of satin
Gradually wrapping cardboard, evenly distribute the position of the tape, securing it glue in different places. Be sure to make sure that the tape does not curl, and did not form creases or folds, it will spoil the appearance of the souvenir. Completely covering the lower part of the base, you must carefully move to the processing of the top of the part.  Eight of Satin Having closed the entire base with a tape, you need to cut it and gently singing the edge of the tape, fix it with glue to did not unravel.
Eight of Satin
Now the ground can be removed to the side, and start working with the creation of jewelry for uvenira. This will require a prepared purple wide ribbon that needs to be cut into square blanks, with a side size of 5 cm. Now they will need 7 pieces.
 Eight of Satin
Of these squares should be done petals for a small flower.To do this, each piece of purple tape must be folded in half, focusing on its diagonal, to get a triangular blank as a result.
 Eight of satin
Two sides with cuts should be folded in several small folds.
Eight of satin
Now the irregularities of the edges need to be fixed by cutting them with scissors, and a new edge is needed Dimo carefully burn with fire to solder the tape layers and simultaneously secure the edge of the petal.
 Eight of satin
Petal can be straightened, giving it a beautiful view.
 Eight of Satin
The result is 7 identical petals. But first, only 5 of them will be needed.
 Eight of Satin
Now they need to be glued together, combining into one flower, combining their bases.
 Eight of satin
The remaining two petals will be used laterthey can be postponed.
Eight of Satin
Then you can proceed to the creation of leaves. For this you need a green ribbon. Two lengths of 6 cm each should be made from it.
 Eight of satin
Having picked up one segment, it must be folded in half, dividing its length, leaving the wrong side inside.
Eight of satin
With the cuts up, the fold should be squeezed with your fingers, starting from the lower right corner and up to the upper left, the detail follows the cut be diagonally.
Eight of satin
You should immediately sing the cuts with fire so that they are soldered together.
Eight of Satin

The result is a voluminous sheet. It is necessary to do the same from the second segment, repeating each action completely.
 Eight of satin
Now you need to put petals left in the middle of the prepared leaves,after having smeared their base with glue.
 Eight of satin
You get neat buds. Then they should be fixed on the eight of the tape. They should be glued in the middle of the part, pointing in different directions, leaving 1 cm between their edges.
 Eight of satin
The left gap should be closed with a created purple flower, after having smeared it from the inside of the glue. The flower itself must be decorated with leaves and a large cabochon glued in the middle.
 Eight of satin
It remains to add a souvenir in rows of crystals. It is necessary to glue them in one row, repeating the bends of the base. Closer to the colors you need to have larger rhinestones, gradually reducing their size. The central flower should be supplemented with two small silver rhinestones attached between the petals.
 Eight of satin
From the wrong side of the eight, in the center, you should glue the magnet.
 Eight of Satin
Souvenir is ready!

Related News


Weather in Sochi for July 2017 - the forecast for the second summer month from the weather center by day. What will be the temperature in July 2017 off the coast of the famous resort
Who will win the Oscar-2018: our predictions
What to wear
How to play sports if you are breastfeeding
Origami Master Class
Salt Dough Home Decoration